Box with 12 cards

This is a selection of 12 cards with a matching box that I made using the lovely Prized Peony suite.
Be sure to check out my Tutorial page where you’ll find a total of 4 videos for this set.
Below are the measurements required for each card and the materials are shown at the end.

Measurements

Card 1 – Quilt effect card

Basic Gray cardstock – 8 1/4″ x 5 3/4″ scored at 4 1/8″ – for card base
2 x Whisper White cardstock – 5 5/8″ x 4″ – for the front and inside of the card
1 x Whisper White cardstock – 5 1/2″ x 3 7/8″ for the ‘quilt’ part
6 x 1st design of DSP – 1 1/4″ x 1 1/4″
4 x 2nd design of DSP – 1 1/4″ x 1 1/4″
1 x scrap piece also at 1 1/4″ x 1/4″

Card 2 – Fancy fold card

Basic Gray cardstock – 8 1/4″ x 5 3/4″ scored at 4 1/8″ – for card base
1 x Whisper White cardstock – 5 5/8″ x 4″ – for inside the card
2 x Whisper White cardstock – 5 5/8″ x 1 3/8″
2 x 1st design of DSP – 5 1/2″ x 1 1/4″
Extra piece of Whisper White Thick cardstock for sentiment
Extra piece of Whisper White cardstock for peony

Card 3 – Frame card

Basic Gray cardstock – 8 1/4″ x 5 3/4″ scored at 4 1/8″ – for card base
Whisper White cardstock – 5 5/8″ x 4″
DSP or Cardstock for the Peony flower
Scrap piece of Basic Gray for the centre of the flower
Scrap piece of Whisper White cardstock for the sentiment

And finally the box!

1 x DSP – 9 1/4″ x 7 1/4″ for lid
1 x Basic Gray cardstock – 11 3/4″ x 9 3/4″
IMPORTANT Extra step – Take a slight piece off one 11 3/4″ side and one 9 3/4″ side. If you miss this step then the lid will not fit.
1 x Whisper White cardstock – 5 1/2″ x 4 1/4″ for stamped image.

Please don’t hesitate to contact me if you would like the measurements for the mats used on the final 6 cards!